Filter
Top Products
Section 9 Bus State Controller
R01UH0134EJ0400 Rev. 4.00 Page 319 of 2108
Sep 24, 2014
SH7262 Group, SH7264 Group
(5) Burst Write
A burst write occurs in the following cases in this LSI.
Access size in writing is larger than data bus width.
Write-back of the cache
16-byte transfer in the direct memory access controller
This LSI always accesses SDRAM with burst length 1. For example, write access of burst length 1
is performed continuously 8 times to write 16-byte continuous data to the SDRAM that is
connected to a 16-bit data bus. This access is called burst write with the burst number 8. The
relationship between the access size and the number of bursts is shown in table 9.12. Figure 9.18
shows a timing chart for burst writes. In burst write, an ACTV command is output in the Tr cycle,
the WRIT command is issued in the Tc1, Tc2, and Tc3 cycles, and the WRITA command is issued
to execute an auto-precharge in the Tc4 cycle. In the write cycle, the write data is output
simultaneously with the write command. After the write command with the auto-precharge is
output, the Trw1 cycle that waits for the auto-precharge initiation is followed by the Tap cycle that
waits for completion of the auto-precharge induced by the WRITA command in the SDRAM.
Between the Trwl and the Tap cycle, a new command will not be issued to the same bank.
However, access to another CS space or another bank in the same SDRAM space is enabled. The
number of Trw1 cycles is specified by the TRWL1 and TRWL0 bits in CS3WCR. The number of
Tap cycles is specified by the WTRP1 and WTRP0 bits in CS3WCR.