Filter
Top Products
Section 9 Bus State Controller
R01UH0134EJ0400 Rev. 4.00 Page 259 of 2108
Sep 24, 2014
SH7262 Group, SH7264 Group
Bit Bit Name
Initial
Value R/W Description
20
BAS 0 R/W SRAM with Byte Selection Byte Access Select
This bit setting is valid only when area 5 is specified
as SRAM with byte selection.
Specifies the WEn and RD/WR signal timing when the
SRAM interface with byte selection is used.
0: Asserts the WEn signal at the read timing and
asserts the RD/WR signal during the write access
cycle.
1: Asserts the WEn signal during the read access
cycle and asserts the RD/WR signal at the write
timing.
19 0 R Reserved
This bit is always read as 0. The write value should
always be 0.
18 to 16 WW[2:0] 000 R/W Number of Write Access Wait Cycles
Specify the number of cycles that are necessary for
write access.
000: The same cycles as WR[3:0] setting (number of
read access wait cycles)
001: No cycle
010: 1 cycle
011: 2 cycles
100: 3 cycles
101: 4 cycles
110: 5 cycles
111: 6 cycles
15 to 13
All 0 R Reserved
These bits are always read as 0. The write value
should always be 0.