Section 27 Video Display Controller 3
Page 1628 of 2108 R01UH0134EJ0400 Rev. 4.00
Sep 24, 2014
SH7262 Group, SH7264 Group
Register Name Setting
VIDEO_DISP_SIZE[24:16] For NTSC: H'0F0
For PAL: H'120
VIDEO_DISP_SIZE[9:0] Specify the horizontal video size to be stored.
SG_MODE[16] H'0
VIDEO_MODE[0] H'1 (This setting starts recording. Set this bit at the end of the
procedure.)
Table 27.18 Register Settings for Stopping Video Recording
Register Name Setting
VIDEO_SAVE_NUM[25:16] These bits hold the field number of which recording processing has
been completed.
VIDEO_MODE[0] H'0 (This setting stops recording. Set this bit at the end of the
procedure.)
27.8.3 How to Use Video Display Mode
Table 27.19 Register Settings for Starting Video Display
Register Name Setting
VIDEO_MODE[21] H'1
VIDEO_MODE[20] H'1
VIDEO_MODE[17] H'0 (IV2-BUS is a big-endian bus)
VIDEO_MODE[16] H'0 (IV1-BUS is a big-endian bus)
VIDEO_MODE[4] H'1
VIDEO_INT_CNT[24] H'0 (This interrupt enable bit is used only for video recording
mode.)
VIDEO_SIZE[24:16] For NTSC: H'0F0
For PAL: H'120
VIDEO_SIZE[9:0] H'2D0