Filter
Top Products
3 - 1
3. CONNECTORS USED FOR SERVO MOTOR WIRING
3. CONNECTORS USED FOR SERVO MOTOR WIRING
POINT
Protective structure indicated for cables and connecters is for a cable or
connector alone. When the cables and connectors are used to connect the
servo amplifier and servo motor, and if protective structures of the servo
amplifier and servo motor are lower than that of the cable and connector,
specifications of the servo amplifier and servo motor apply.
3.1 Makeups
This section gives connector makeups on an operating environment basis. Use the models of the
manufacturers given or equivalent.
3.1.1 HC-KF(-UE)
HC-MF(-UE) HA-FF HC-UF3000r/min series
Use round crimping terminals (1.25-4) for connection of the power supply and electromagnetic brake. For
connection of the encoder, use the connector indicated in this section or equivalent. This connector may be
used with the EN Standard and UL/C-UL Standard but is not waterproof.
Cable Side Connector
Servo Motor
Connector Supplied for
Servo Motor
(Tyco Electronics)
Housing
(Tyco Electronics)
Connector Pin
(Tyco Electronics)
Cable Clamp
(Toa Electric Industry)
HC-KF (B)
HC-KF
(B)-UE
HC-MF
(B)
HC-MF
(B) -UE
HA-FF
(B)
HC-UF13 to 73(B)
1-172169-9 1-172161-9
170359-1
170363-1 (loose piece)
MTI-0002
3.1.2 HA-FF C-UE series
If used with a waterproof connector, the HA-FF
C(B)-UE does not improve in ingress protection (IP54).
(1) Non-waterproof, UL/C-UL Standard-compliant
(a) When using cabtyre cables
1) For connection of power supply
1) Plug
2) Cable
clamp
Cable 1) Plug
2) Cable
clamp
Cable
Cable Side Connector
1) Plug (DDK)
Servo Motor
Connector Supplied for
Servo Motor
Type Model
2) Cable clamp
(DDK)
Straight D/MS3106B14S-2S
HA-FF C(B) -UE CE05-2A14S-2PD-B
Angle D/MS3108B14S-2S
D/MS3057-6A