Filter
Top Products
FX Series Programmable Controllers Related Information 9
9-37
3 ) Setting of general-purpose ROM writer
Refer to the manual of the general-purpose ROM writer, set the communication condition in the ROM
writer within the range shown in the table below, and make the ROM writer ready for communication.
When a latest personal computer is used, the baud rate may be set to a larger value.
*1 When writing a ROM for the GOT-F900, make sure to set this item because the CPU is the Risc type.
The command for the ROM writer is "[SET][-][B]".
%
The communication condition shown above should be able to be set in the used general-purpose
ROM writer.
Preparation is completed.
2. Preparation of Hyper Terminal software
This paragraph describes the connection to transfer the screen data stored in the memory inside a personal
computer and the data stored in the memory built in a general-purpose ROM writer. This paragraph
describes also as an example the procedure to transfer the data using the communication software (Hyper
Terminal) offered as an accessory of the Windows.
1 ) Startup
a ) Click the Start button.
b ) Point "Program" using the mouse. The window showing installed applications is open.
c ) Point the "Accessory" folder.
d ) Click the "Hyper Terminal" folder on the sub menu.
e ) The "Hyper Terminal" folder is open.
f ) Click the "Hypertrm" icon to start up the Hyper Terminal software.
Table 9.55:
Item Allowable set range ("[ ]" indicates an initial value.) Set value
Baud rate (bps)
[9600], 4800, 2400, 1200, 600
Data bit length (bits)
[7], 8,
Stop bit length (bits)
[1], 2,
Parity check
[None], odd, even
Transfer format
Only "Intel HEX" is allowed. Intel HEX
Word type
*1
Even-High; Low, [High] High
b)
a)
d)
c)
f)