Filter
Top Products
Cisco IOS Voice, Video, and Fax Commands: R Through Sh
response-timeout
VR-569
Cisco IOS Voice, Video, Fax Command Reference
response-timeout
To configure the maximum time to wait for a response from a server, use the response-timeout
command in settlement configuration mode. To restore the default value of this command, use the no
form of this command.
response-timeout number
no response-timeout number
Syntax Description
Defaults The default response timeout is one (1) second.
Command Modes Settlement configuration
Command History
Usage Guidelines If no response is received within the response-timeout time limit, the current connection ends, and the
router attempts to contact the next service point.
Examples The following example illustrates a response-timeout set to 1 second.
settlement 0
response-timeout 1
Related Commands
number Response waiting time in seconds.
Release Modification
12.0(4)XH1 This command was introduced on the Cisco 2600 series and Cisco 3600
series routers and the Cisco AS5300 universal access server.
12.1(1)T This command was integrated into Cisco IOS Release 12.1(1)T.
Command Description
connection-timeout Configures the time for which a connection is maintained after completion
of a communication exchange.
customer-id Identifies a carrier or ISP with a settlement provider.
device-id Specifies a gateway associated with a settlement provider.
encryption Sets the encryption method to be negotiated with the provider.
max-connection Sets the maximum number of simultaneous connections to be used for
communication with a settlement provider.
retry-delay Sets the time between attempts to connect with the settlement provider.
retry-limit Sets the maximum number of attempts to connect to the provider.