Filter
Top Products
Cisco IOS Voice, Video, and Fax Commands: R Through Sh
sgcp
VR-623
Cisco IOS Voice, Video, Fax Command Reference
sgcp
To start and allocate resources for the Simple Gateway Control Protocol (SGCP) daemon, use the sgcp
command in global configuration mode. To terminate all calls, release all allocated resources, and kill
the SGCP daemon, use the no form of this command.
sgcp
no sgcp
Syntax Description This command has no arguments or keywords.
Defaults The SGCP daemon is not enabled.
Command Modes Global configuration
Command History
Usage Guidelines When the SGCP daemon is not active, all SGCP messages are ignored.
When you enter the no sgcp command, the SGCP process is removed.
Note After you enter the no sgcp command, you must save the configuration and reboot the router for the
disabling of SGCP to take effect.
Examples The following example shows the SGCP daemon being enabled:
sgcp
The following example shows the SGCP daemon being disabled:
no sgcp
Release Modification
12.0(5)T This command was introduced in a private release on the
Cisco AS5300 universal access server only and was not generally
available.
12.0(7)XK Support for this command was extended to the Cisco MC3810
multiservice concentrator and the Cisco 3600 series routers (except
for the Cisco 3620) in a private release that was not generally
available.
12.1(2)T This command was integrated into 12.1(2)T and was generally
available on the Cisco 3600 series router and the Cisco MC3810
multiservice concentrator