Filter
Top Products
Cisco IOS Voice, Video, and Fax Commands: R Through Sh
shutdown (gatekeeper)
VR-866
Cisco IOS Voice, Video, Fax Command Reference
shutdown (gatekeeper)
To disable the gatekeeper, use the shutdown command in gatekeeper configuration mode. To enable the
gatekeeper, use the no form of this command.
shutdown
no shutdown
Syntax Description This command has no arguments or keywords.
Defaults Disabled (shut down)
Command Modes gatekeeper configuration
Command History
Usage Guidelines The gatekeeper does not have to be enabled before you can use the other gatekeeper configuration
commands. In fact, it is recommended that you complete the gatekeeper configuration before bringing
up the gatekeeper because some characteristics may be difficult to alter while the gatekeeper is running,
as there may be active registrations or calls.
The no shutdown command enables the gatekeeper, but it does not make the gatekeeper operational. The
two exceptions to this are as follows:
• If no local zones are configured, a no shutdown command places the gatekeeper in INACTIVE
mode waiting for a local zone definition.
• If local zones are defined to use an HSRP virtual address, and the HSRP interface is in STANDBY
mode, the gatekeeper goes into HSRP STANDBY mode. Only when the HSRP interface is ACTIVE
will the gatekeeper go into the operational UP mode.
Examples The following command disables a gatekeeper:
shutdown
Release Modification
11.3(2)NA This command was introduced on the Cisco 2500 series and Cisco 3600
series routers.
12.0(3)T The command was integrated into Cisco IOS Release 12.0(3)T and
supported on the Cisco MC3810 multiservice concentrator.