Filter
Top Products
Cisco IOS Voice, Video, and Fax Commands: R Through Sh
sgcp request retries
VR-635
Cisco IOS Voice, Video, Fax Command Reference
sgcp request retries
To specify the number of times to retry sending “notify” and “delete” messages to the Simple Gateway
Control Protocol (SGCP) call agent, use the sgcp request retries command in global configuration
mode. To restore the default value, use the no form of this command.
sgcp request retries count
no sgcp request retries
Syntax Description
Defaults The default for the number of times a “notify” and “delete” message is retransmitted to the SGCP call
agent before it is dropped is 3
Command Modes Global configuration
Command History
Usage Guidelines The actual retry count may be different from the value you enter for this command. The retry count is
also limited by the call agent. If there is no response from the call agent after 30 seconds, the gateway
will not retry anymore, even though the number set using the sgcp request retries command has not
been reached.
The router will stop sending retries after 30 seconds, regardless of the setting for this command.
Examples The following example shows the system configured to send the sgcp command 10 times before
dropping the request:
sgcp request retries 10
count Specifies the number of times a “notify” and “delete” message
is retransmitted to the SGCP call agent before it is dropped. The
valid range is from 1 to 100. The default is 3.
Release Modification
12.0(5)T This command was introduced in a private release on the
Cisco AS5300 universal access server only and was not
generally available.
12.0(7)XK Support for this command was extended to the Cisco MC3810
multiservice concentrator and the Cisco 3600 series routers
(except for the Cisco 3620) in a private release that was not
generally available.
12.1(2)T This command was integrated into 12.1(2)T and was generally
available on the Cisco 3600 series router and the
Cisco MC3810 multiservice concentrator