Filter
Top Products
Cisco IOS Voice, Video, and Fax Commands: R Through Sh
sgcp call-agent
VR-625
Cisco IOS Voice, Video, Fax Command Reference
sgcp call-agent
To define the IP address of the default Simple Gateway Control Protocol (SGCP) call agent in the router
configuration file, use the sgcp call-agent command in global configuration mode. To remove the IP
address of the default SGCP call agent from the router configuration, use the no form of this command.
sgcp call-agent ipaddress [:udp port]
no sgcp call-agent ipaddress
Syntax Description
Defaults No IP address is configured.
Command Modes Global configuration
Command History
Usage Guidelines Setting this command defines the IP address of the default SGCP call agent to which the router sends an
initial RSIP (Restart In Progress) packet when the router boots up. This is used for initial boot-up only
before the SGCP call agent contacts the router acting as the gateway.
When you enter the no sgcp call-agent command, only the IP address of the default SGCP call agent is
removed.
Examples The following example shows SGCP being enabled and the IP address of the call agent being specified:
sgcp
sgcp call-agent 209.165.200.225
ipaddress Specifies the IP address or hostname of the call agent.
:udp port (Optional) Specifies the UDP port of the call agent.
Release Modification
12.0(5)T This command was introduced in a private release on the
Cisco AS5300 universal access server only and was not generally
available.
12.0(7)XK Support for this command was extended to the Cisco MC3810
multiservice concentrator and the Cisco 3600 series routers (except
for the Cisco 3620) in a private release that was not generally
available.
12.1(2)T This command was integrated into 12.1(2)T and was generally
available on the Cisco 3600 series router and the Cisco MC3810
multiservice concentrator