Filter
Top Products
Cisco IOS Voice, Video, and Fax Commands: R Through Sh
show voice call
VR-825
Cisco IOS Voice, Video, Fax Command Reference
For the Cisco MC3810 Multiservice Concentrator with Analog Voice Ports:
For the Cisco MC3810 Multiservice Concentrator with Digital Voice Ports:
Command Modes EXEC
Command History
Usage Guidelines The show voice call command applies to Voice over Frame Relay, Voice over ATM, and Voice over IP.
This command shows call-processing and protocol state-machine information for a voice port, if it is
available. It also shows information on the DSP channel associated with the voice port, if it is available.
All real-time information in the DSP channel, such as jitter and buffer overrun for example, is queried
to the DSP channel, and asynchronous responses are returned to the host side.
If no call is active on a voice port, the show voice call summary command displays only the VPM
(shutdown) state. If a call is active on a voice port, the VTSPS state is shown. For an on-net call or a
local call without local-bypass (not cross-connected), the CODEC and VAD fields are displayed. For an
off-net call or a local call with local-bypass, the CODEC and VAD fields are not displayed.
CODEC and VAD are not displayed by the show voice call command because this information is in the
summary display.
slot/port (Optional) Displays information for the analog voice port you specify
with the slot/port designation.
• slot is the physical slot in which the analog voice module (AVM) is
installed. The slot is always 1 for analog voice ports in the
Cisco MC3810 multiservice concentrator.
• port specifies an analog voice port number. Valid entries are from 1
to 6.
summary (Optional) Displays a summary of all voice ports.
slot:ds0-group (Optional) Displays information for the digital voice port you specify
with the slot:ds0-group designation.
• slot specifies the module (and controller). Valid entries are 0 for the
MFT (controller 0) and 1 for the DVM (controller 1).
• ds0-group specifies a T1 or E1 logical voice port number. Valid
entries are 0 to 23 for T1 and 0 to 30 for E1.
summary (Optional) Displays a summary of all voice ports.
Release Modification
11.3(1)MA This command was introduced for the Cisco MC3810 multiservice
concentrator.
12.0(7)XK This command was first supported on the Cisco 2600 and 3600 series.
12.1(2)T This command was integrated into the 12.1(2)T release.