Filter
Top Products
Cisco IOS Voice, Video, and Fax Commands: R Through Sh
show pots status
VR-754
Cisco IOS Voice, Video, Fax Command Reference
show pots status
To display the settings of the telephone port physical characteristics and other information on the
telephone interfaces of the Cisco 800 series, use the show pots status command in privileged EXEC
mode.
show pots status [1 | 2]
Syntax Description
Defaults No default behavior or values.
Command Modes Privileged EXEC
Command History
Usage Guidelines The show pots status command displays the settings and information for both telephone ports.
Examples The following is sample output from the show pots status command.
Router# show pots status
POTS Global Configuration:
Country: United States
Dialing Method: Overlap, Tone Source: Remote, CallerId Support: YES
Line Type: 600 ohm, PCM Encoding: u-law, Disc Type: OSI,
Ringing Frequency: 20Hz, Distinctive Ring Guard timer: 0 msec
Disconnect timer: 1000 msec, Disconnect Silence timer: 5 sec
TX Gain: 6dB, RX Loss: -6dB,
Filter Mask: 6F
Adaptive Cntrl Mask: 0
POTS PORT: 1
Hook Switch Finite State Machine:
State: On Hook, Event: 0
Hook Switch Register: 10, Suspend Poll: 0
CODEC Finite State Machine:
State: Idle, Event: 0
Connection: None, Call Type: Two Party, Direction: Rx only
Line Type: 600 ohm, PCM Encoding: u-law, Disc Type: OSI,
Ringing Frequency: 20Hz, Distinctive Ring Guard timer: 0 msec
Disconnect timer: 1000 msec, Disconnect Silence timer: 5 sec
TX Gain: 6dB, RX Loss: -6dB,
Filter Mask: 6F
Adaptive Cntrl Mask: 0
1 (Optional) Display the settings of telephone port 1.
2 (Optional) Display the settings of telephone port 2.
Release Modification
12.0(3)T This command was introduced on the Cisco 800 series router.