Filter
Top Products
Cisco IOS Voice, Video, and Fax Commands: R Through Sh
show call history
VR-676
Cisco IOS Voice, Video, Fax Command Reference
Modem passthrough
signaling method is nse
Indicates that this is a modem pass-through call and named signaling
events (NSEs)—also called telephone-events in RFC 2833—are used for
signaling codec upspeed. The upspeed method is the method used to
dynamically change the codec type and speed to meet network
conditions. This means that you might move to a faster codec when you
have both voice and data calls and then slow down when there is only
voice traffic.
NoiseLevel Average noise level for this call.
OnTimeRvPlayout Duration of voice playout from data received on time for this call.
Derive the Total Voice Playout Duration for Active Voice by adding the
OnTimeRvPlayout value to the GapFill values.
Percent Packet Loss Total percent packet loss.
PeerAddress Destination pattern or number associated with this peer.
PeerId ID value of the peer entry table to which this call was made.
PeerIfIndex Voice port index number for this peer. For ISDN media, this would be
the index number of the B channel used for this call.
PeerSubAddress Subaddress where this call is connected.
ReceiveBytes Number of bytes received by the peer during this call.
ReceiveDelay Average Playout FIFO Delay plus the Decoder Delay during this voice
call.
ReceivePackets Number of packets received by this peer during this call.
RemoteIPAddress Remote system IP address for this call.
RemoteUDPPort Remote system UDP listener port to which voice packets are sent.
RoundTripDelay Voice packet round-trip delay between the local and remote systems on
the IP backbone for this call.
SelectedQoS Selected RSVP QoS for this call.
Session Protocol Session protocol used for an Internet call between the local and remote
router through the IP backbone.
Session Target Session target of the peer used for this call.
SetUpTime Value of the system UpTime when the call associated with this entry was
started.
SignalingType Signaling type for this call, for example, channel-associated signaling
(CAS) or common-channel signaling (CCS).
Time between Buffer
Drain/Fills
Minimum and maximum durations between jitter buffer drain or fill
events, in seconds.
TransmitBytes Number of bytes sent by this peer during this call.
TransmitPackets Number of packets sent by this peer during this call.
TxDuration Duration of the transmit path open from this peer to the voice gateway
for this call.
Table 28 show call history Field Descriptions (continued)
Field Description