Filter
Top Products
Cisco IOS Voice, Video, and Fax Commands: R Through Sh
sgcp timer
VR-643
Cisco IOS Voice, Video, Fax Command Reference
sgcp timer
To configure how the gateway detects the Real-Time Transport Protocol (RTP) stream lost, use the sgcp
timer command in global configuration mode. To restore the default value, use the no form of this
command.
sgcp timer {receive-rtcp timer | rtp-nse timer}
no sgcp timer {receive-rtcp timer | rtp-nse timer}
Syntax Description
Defaults Default for receive-rtcp timer is 5.
Default for rtp-nse timer is 200.
Command Modes Global configuration
Command History
Usage Guidelines The RTP NSE timer is used for proxy ringing (the ringback tone is provided at the originating gateway).
Examples The following example shows the receive-rtcp timer set to 100 milliseconds:
sgcp timer receive-rtcp 100
The following example shows the rtp-nse timer set to 1000 milliseconds:
sgcp timer rtp-nse 1000
receive-rtcp timer Sets the multiples of the RTP Control Protocol (RTCP) transmission
interval in milliseconds. The valid range is from 1 to 100, and the default
is 5.
rtp-nse timer Sets the multiples of the RTP named signaling event (NSE) timeout in
milliseconds. The valid range is from 100 to 3000, and the default is
200.
Release Modification
12.0(5)T This command was introduced in a private release on the Cisco AS5300
universal access server only and was not generally available.
12.0(7)XK Support for this command was extended to the Cisco MC3810
multiservice concentrator and the Cisco 3600 series routers (except for
the Cisco 3620) in a private release that was not generally available.
12.1(2)T This command was integrated into 12.1(2)T and was generally available
on the Cisco 3600 series router and the Cisco MC3810 multiservice
concentrator