Filter
Top Products
Cisco IOS Voice, Video, and Fax Commands: R Through Sh
shut
VR-863
Cisco IOS Voice, Video, Fax Command Reference
shut
To shut down a set of digital signal processors (DSPs) on the Cisco 7200 series router, use the shut
command in DSP configuration mode. To put DSPs back in service, use the no form of this command.
shut number
no shut number
Syntax Description
Defaults no shut
Command Modes DSP configuration
Command History
Usage Guidelines This command applies to Voice over IP on the Cisco 7200 series routers.
Examples The following example shuts down two sets of DSPs:
shut 2
number Number of DSPs to be shut down.
Release Modification
12.0(5)XE This command was introduced on the Cisco 7200 series router.
12.1(1)T This command was modified to add information about DSP groups.