Filter
Top Products
Cisco IOS Voice, Video, and Fax Commands: R Through Sh
show voice call
VR-824
Cisco IOS Voice, Video, Fax Command Reference
show voice call
To show the call status for voice ports on the Cisco router or concentrator, use the show voice call EXEC
command.
Cisco 2600 and 3600 series with Analog Voice Ports
show voice call [slot/subunit/port | summary]
Cisco 2600 and 3600 Series with Digital Voice Ports (with T1 Packet Voice Trunk Network Modules)
show voice call [slot/port:ds0-group | summary]
Cisco MC3810 Multiservice Concentrator with Analog Voice Ports
show voice call [slot/port | summary]
Cisco MC3810 Multiservice Concentrator with Digital Voice Ports
show voice call [slot:ds0-group | summary]
Syntax Description
For the Cisco 2600 and 3600 Series with Analog Voice Ports:
For the Cisco 2600 and 3600 Series with Digital Voice Ports:
slot/subunit/port (Optional) Displays information for the analog voice port you specify with
the slot/subunit/port designation.
• slot specifies a router slot in which a voice network module (NM) is
installed. Valid entries are router slot numbers for the particular
platform.
• subunit specifies a voice interface card (VIC) where the voice port is
located. Valid entries are 0 and 1. (The VIC fits into the voice network
module.)
• port specifies an analog voice port number. Valid entries are 0 and 1.
summary (Optional) Displays a summary of all voice ports.
slot/port:ds0-group (Optional) Displays information for the digital voice port you specify with
the slot/port:ds0-group designation.
• slot specifies a router slot in which the packet voice trunk network
module (NM) is installed. Valid entries are router slot numbers for the
particular platform.
• port specifies a T1 or E1 physical port in the voice WAN interface card
(VWIC). Valid entries are 0 and 1. (One VWIC fits in an NM.)
• ds0-group specifies a T1 or E1 logical port number. Valid entries are 0
to 23 for T1 and 0 to 30 for E1.
summary (Optional) Displays a summary of all voice ports.