Filter
Top Products
Cisco IOS Voice, Video, and Fax Commands: R Through Sh
show mgcp connection
VR-746
Cisco IOS Voice, Video, Fax Command Reference
Related Commands
(P)ort The ports used for this connection. The first port is the local UDP port.
The second port is the remote UDP port.
(M)ode The call mode, where:
0—An invalid value for mode.
1—The gateway should only send packets.
2—The gateway should only receive packets.
3—The gateway can send and receive packets.
4—The gateway should neither send nor receive packets.
5—The gateway should place the circuit in loopback mode.
6—The gateway should place the circuit in test mode.
7—The gateway should use the circuit for network access for data.
8—The gateway should place the connection in network loopback
mode.
9—The gateway should place the connection in network continuity
test mode.
10— The gateway should place the connection in conference mode.
All other values are used for internal debugging.
(S)tate The call state. The values are used for internal debugging purposes.
(C)odec The codec identifier. The values are used for internal debugging
purposes.
(E)vent [SIFL] Used for internal debugging.
(R)esult [EA] Used for internal debugging.
Table 47 show mgcp connection Field Descriptions (continued)
Command Description
mgcp Starts the MGCP daemon.
show mgcp Displays general MGCP configuration information.
show mgcp endpoint Displays endpoint-specific MGCP configuration information.
show mgcp statistics Displays statistical MGCP configuration information.