Filter
Top Products
Cisco IOS Voice, Video, and Fax Commands: R Through Sh
sgcp tse payload
VR-645
Cisco IOS Voice, Video, Fax Command Reference
sgcp tse payload
To enable Inband Telephony Signaling Events (TSE) for fax and modem operation, use the sgcp tse
payload command in global configuration mode. To restore the default value, use the no form of this
command.
sgcp tse payload type
no sgcp tse payload type
Syntax Description
Defaults Zero (0)
Command Modes Global configuration
Command History
Usage Guidelines Because this command is disabled by default, you must specify a TSE payload type.
If you configure the sgcp modem passthru command to the nse value, then you must configure this
command.
Examples The following example shows the Simple Gateway Control Protocol (SGCP) modem pass-through set
using the NSE-based modem upspeed and the Inband Telephony Signaling Events payload value set to
110:
sgcp modem passthru nse
sgcp tse payload 110
Related Commands
type Sets the TSE payload type. The valid range is from 96 to 119. The
default is 0, meaning that the command is disabled.
Release Modification
12.0(7)XK This command was introduced on the Cisco MC3810 multiservice
concentrator and Cisco 3600 series routers (except the Cisco 3620) in a
private release that was not generally available.
12.1(2)T This command was integrated into 12.1(2)T and was generally available
on the Cisco 3600 series router and the Cisco MC3810 multiservice
concentrator
Command Description
sgcp Starts and allocates resources for the SGCP daemon.
sgcp call-agent Defines the IP address of the default SGCP call agent.
sgcp graceful-shutdown Gracefully terminates all SGCP activity.