Filter
Top Products
Cisco IOS Voice, Video, and Fax Commands: R Through Sh
show sgcp endpoint
VR-789
Cisco IOS Voice, Video, Fax Command Reference
show sgcp endpoint
To see SGCP endpoints eligible for SGCP management, use the show sgcp endpoint command in EXEC
mode.
show sgcp endpoint [interface ds1 [ds0]]
Syntax Description
Defaults No default behavior or values.
Command Modes EXEC
Command History
Usage Guidelines You can use this command to see SGCP endpoint information for the whole router, or you can see SGCP
endpoint information for a specific DS1 interface and, optionally, a specific DS0. If you enter a
nonexistent combination of a DS1 and DS0, the following error message appears: “No matching
connection found.”
Examples The following command shows SGCP endpoint information being set for a matching connection
between DS1 interface 1 and DS0 interface 10:
Router# show sgcp endpoint interface 1 10
interface ds1 (Optional) Specifies the DS1 interface for which to display SGCP
endpoint information. The valid range is from 1 to 1000.
ds0 (Optional) Specifies the DS0 interface for which to display SGCP
endpoint information. The valid range is from 0 to 30.
Release Modification
12.0(5)T This command was introduced in a private release on the Cisco AS5300
universal access server only and was not generally available.
12.0(7)XK Support for this command was extended to the Cisco MC3810
multiservice concentrator and the Cisco 3600 series routers (except for
the Cisco 3620) in a private release that was not generally available.