Filter
Top Products
Cisco IOS Voice, Video, and Fax Commands: R Through Sh
sequence-numbers
VR-593
Cisco IOS Voice, Video, Fax Command Reference
Related Commands Command Description
called-number
(dial-peer)
Enables an incoming VoFR call leg to get bridged to the correct POTS call
leg when using a static FRF.11 trunk connection.
codec (dial-peer) Specifies the voice coder rate of speech for a Voice over Frame Relay dial
peer.
cptone Specifies a regional analog voice interface-related tone, ring, and cadence
setting.
destination-pattern Specifies either the prefix, the full E.164 telephone number, or an ISDN
directory number (depending on the dial plan) to be used for a dial peer.
dtmf-relay (Voice over
Frame Relay)
Enables the generation of FRF.11 Annex A frames for a dial peer.
session protocol
(Voice over Frame
Relay)
Establishes a session protocol for calls between the local and remote routers
via the packet network.
session target Specifies a network-specific address for a specified dial peer or destination
gatekeeper.
signal-type Sets the signaling type to be used when connecting to a dial peer.