Filter
Top Products
Cisco IOS Voice, Video, and Fax Commands: R Through Sh
show interface dspfarm
VR-737
Cisco IOS Voice, Video, Fax Command Reference
show interface dspfarm
To display digital signal processor (DSP) information on the two-port T1/E1 high-density port adapter
for the Cisco 7200 series, use the show interface dspfarm command in privileged EXEC mode.
show interface dspfarm [slot/port]
Syntax Description
Defaults No default behavior or values.
Command Modes Privileged EXEC
Command History
Usage Guidelines The local time-division multiplexing (TDM) cross-connect map can be displayed.
Examples The following example is sample output from the show interface dspfarm command for port adapter
slot 0 of chassis slot 3, on the Cisco 7200 series router:
Router# show interface dspfarm 3/0
DSPfarm3/0 is up, line protocol is up
Hardware is VXC-2T1/E1
MTU 256 bytes, BW 12000 Kbit, DLY 0 usec,
reliability 255/255, txload 4/255, rxload 1/255
Encapsulation VOICE, loopback not set
C549 DSP Firmware Version:MajorRelease.MinorRelease (BuildNumber)
DSP Boot Loader:255.255 (255)
DSP Application:4.0 (3)
Medium Complexity Application:3.2 (5)
High Complexity Application:3.2 (5)
Total DSPs 30, DSP0-DSP29, Jukebox DSP id 30
Down DSPs:none
Total sig channels 120 used 24, total voice channels 120 used 0
0 active calls, 0 max active calls, 0 total calls
30887 rx packets, 0 rx drops, 30921 tx packets, 0 tx frags
0 curr_dsp_tx_queued, 29 max_dsp_tx_queued
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy:fifo
Output queue 0/0, 0 drops; input queue 0/75, 0 drops
5 minute input rate 13000 bits/sec, 94 packets/sec
5 minute output rate 193000 bits/sec, 94 packets/sec
slot (Optional) Slot location of the port adapter.
/port (Optional) Port number on the port adapter.
Release Modification
12.0(5)XE This command was introduced on the Cisco 7200 series router.
12.1(1)T This command was integrated into the Cisco IOS 12.1(1)T.