Filter
Top Products
Cisco IOS Voice, Video, and Fax Commands: R Through Sh
show csm
VR-705
Cisco IOS Voice, Video, Fax Command Reference
csm_state CSM call state of the current call (PRI line) associated with this device.
Possible values are as follows:
• CSM_IDLE_STATE—Device is idle.
• CSM_IC_STATE—A device has been assigned to an incoming call.
• CSM_IC1_COLLECT_ADDR_INFO—A device has been selected
to perform ANI/DNIS address collection for this call. ANI/DNIS
address information collection is in progress. The ANI/DNIS is
used to decide whether the call should be processed by a modem or
a voice DSP.
• CSM_IC2_RINGING—The device assigned to this incoming call
has been told to get ready for the call.
• CSM_IC3_WAIT_FOR_SWITCH_OVER—A new device is
selected to take over this incoming call from the device collecting
the ANI/DNIS address information.
• CSM_IC4_WAIT_FOR_CARRIER—This call is waiting for the
CONNECT message from the carrier.
• CSM_IC5_CONNECTED—This incoming call is connected to the
central office.
• CSM_IC6_DISCONNECTING—This incoming call is waiting for
a DISCONNECT message from the VTSP module to complete the
disconnect process.
• CSM_OC_STATE —An outgoing call is initiated.
• CSM_OC1_REQUEST_DIGIT—The device is requesting the first
digit for the dial-out number.
• CSM_OC2_COLLECT_1ST_DIGIT—The first digit for the
dial-out number has been collected.
• CSM_OC3_COLLECT_ALL_DIGIT—All the digits for the
dial-out number have been collected.
• CSM_OC4_DIALING—This call is waiting for a dsx0 (B channel)
to be available for dialing out.
• CSM_OC5_WAIT_FOR_CARRIER—This (outgoing) call is
waiting for the central office to connect.
• CSM_OC6_CONNECTED—This (outgoing) call is connected.
• CSM_OC7_BUSY_ERROR—A busy tone has been sent to the
device (for VoIP call, no busy tone is sent; just a DISCONNECT
INDICATION message is sent to the VTSP module),and this call is
waiting for a DISCONNECT message from the VTSP module (or
ONHOOK message from the modem) to complete the disconnect
process.
• CSM_OC8_DISCONNECTING—The central office has
disconnected this (outgoing) call, and the call is waiting for a
DISCONNECT message from the VTSP module to complete the
disconnect process.
Table 34 show csm voice Field Descriptions (continued)
Field Description