Filter
Top Products
Cisco IOS Voice, Video, and Fax Commands: R Through Sh
session target (VoATM)
VR-609
Cisco IOS Voice, Video, Fax Command Reference
Related Commands Command Description
called-number Enables an incoming VoFR call leg to be bridged to the correct POTS
call leg.
codec (dial-peer) Specifies the voice coder rate of speech for a dial peer.
cptone Specifies a regional tone, ring, and cadence setting for an analog voice
port.
destination-pattern Specifies either the prefix or the full E.164 telephone number
(depending on your dial plan) to be used for a dial peer.
dtmf-relay Enables the DSP to generate FRF.11 Annex A frames for a dial peer.
preference Indicates the preferred selection order of a dial peer within a hunt
group.
session protocol Establishes a VoFR protocol for calls between the local and the remote
routers via the packet network.
signal-type Sets the signaling type to be used when connecting to a dial peer.