Filter
Top Products
Cisco IOS Voice, Video, and Fax Commands: R Through Sh
show dial-peer voice
VR-711
Cisco IOS Voice, Video, Fax Command Reference
Related Commands
huntstop Indicates whether dial-peer hunting has been turned on, by using the
huntstop command, for this dial peer.
Icpif Configured Calculated Planning Impairment Factor (ICPIF) value for
calls sent by a dial peer.
incall-number Full E.164 telephone number to be used to identify the dial peer.
incoming called-number Indicates the incoming called number if it has been set by using the
incoming-called number command.
information type Information type for this call; for example, voice or fax.
Last Disconnect Cause Encoded network cause associated with the last call. This value will be
updated whenever a call is started or cleared and depends on the
interface type and session protocol being used on this interface.
Last Disconnect Text ASCII text describing the reason for the last call termination.
Last Setup Time Value of the System Up Time when the last call to this peer was started.
Modem passthrough Modem pass-through signaling method is named signaling event (NSE).
Operation state Operational state of this peer.
Payload type NSE payload type.
Permission Configured permission level for this peer.
Poor QOV Trap Whether Poor Quality of Voice trap messages have been enabled or
disabled.
Redundancy Packet redundancy (RFC 2198) for modem traffic.
Refused Calls Number of calls from this peer refused since system startup.
req-qos Configured requested quality of service for calls for this dial peer.
session-target Session target of this peer.
sess-proto Session protocol to be used for Internet calls between local and remote
routers through the IP backbone.
Successful Calls Number of completed calls to this peer.
tag Unique dial peer ID number.
VAD Whether voice activation detection (VAD) is enabled for this dial peer.
Table 35 show dial-peer voice Field Descriptions (continued)
Field Description
Command Description
show call active voice Displays the Voice over IP active call table.
show call history voice Displays the Voice over IP call history table.
show num-exp Displays how the number expansions are configured in Voice over IP.
show voice port Displays configuration information about a specific voice port.