Filter
Top Products
Cisco IOS Voice, Video, and Fax Commands: R Through Sh
show dialplan number
VR-717
Cisco IOS Voice, Video, Fax Command Reference
direct-inward-dial = disabled,
Connect Time = 0, Charged Units = 0,
Successful Calls = 0, Failed Calls = 0, Incomplete Calls = 0
Accepted Calls = 0, Refused Calls = 0,
Last Disconnect Cause is "",
Last Disconnect Text is "",
Last Setup Time = 0.
Matched: 1001 Digits: 4
Target:
VoiceEncapPeer1004
information type = voice,
tag = 1004, destination-pattern = `1001',
answer-address = `', preference=0,
numbering Type = `unknown'
group = 1004, Admin state is up, Operation state is up,
...
Matched: 1001 Digits: 4
Target:
VoiceEncapPeer1002
information type = voice,
tag = 1002, destination-pattern = `1001',
answer-address = `', preference=0,
numbering Type = `unknown'
group = 1002, Admin state is up, Operation state is up,
...
Matched: 1001 Digits: 4
Target:
VoiceEncapPeer1001
information type = voice,
tag = 1001, destination-pattern = `1001',
answer-address = `', preference=0,
numbering Type = `unknown'
group = 1001, Admin state is up, Operation state is up,
...
Matched: 1001 Digits: 4
Target:
The following example shows sample output from the show dialplan number command using the
destination pattern of 1001 and the huntstop keyword:
Router# show dialplan number 1001 huntstop
Macro Exp.: 1001
VoiceEncapPeer1003
information type = voice,
tag = 1003, destination-pattern = `1001',
answer-address = `', preference=0,
numbering Type = `unknown'
group = 1003, Admin state is up, Operation state is up,
incoming called-number = `', connections/maximum = 0/unlimited,
DTMF Relay = disabled,
huntstop = enabled,
type = pots, prefix = `',
forward-digits default
session-target = `', voice-port = `1/1',
direct-inward-dial = disabled,
Connect Time = 0, Charged Units = 0,
Successful Calls = 0, Failed Calls = 0, Incomplete Calls = 0
Accepted Calls = 0, Refused Calls = 0,
Last Disconnect Cause is "",