Filter
Top Products
Cisco IOS Voice, Video, and Fax Commands: R Through Sh
session target (VoATM)
VR-608
Cisco IOS Voice, Video, Fax Command Reference
Command History
Usage Guidelines Use the session target command to specify a network-specific address or domain name for a dial peer.
Whether you select a network-specific address or a domain name depends on the session protocol you
select. The syntax of this command complies with the simple syntax of mailto: as described in RFC 1738.
The session target loopback command is used for testing the voice transmission path of a call. The
loopback point will depend on the call origin and the loopback type selected.
This command applies to on-ramp store-and-forward fax functions.
You must enter the session protocol aal2-trunk dial-peer configuration command before you can
specify a cid for a dial peer for VoATM on the Cisco MC3810 multiservice concentrator.
Note This command does not apply to plain old telephone service (POTS) dial peers.
Examples The following example configures a session target for Voice over ATM on a Cisco MC3810 multiservice
concentrator. The session target is sent to ATM interface 0, and for a PVC with a VCI of 20.
dial-peer voice 12 voatm
destination-pattern 13102221111
session target atm0 pvc 20
The following example delivers fax-mail to multiple recipients:
dial-peer voice 10 mmoip
session target marketing-information@mailer.example.com
Assuming that mailer.example.com is running sendmail, you can put the following information into its
/etc/aliases file:
marketing-information:
john@example.com,
fax=+14085551212@sj-offramp.example.com
The following example displays configuring a session target for Voice over ATM on the Cisco 3600
series. The session target is sent to ATM interface 0, and is for a PVC with a VPI/VCI of 1/100.
dial-peer voice 12 voatm
destination-pattern 13102221111
session target atm1/0 pvc 1/100
Release Modification
11.3(1)T This command was introduced.
11.3(1)MA Support was added for VoATM, VoHDLC, and POTS dial peers on the
Cisco MC3810 multiservice concentrator.
12.0(7)XK Support was added for VoATM dial peers on the Cisco 3600 series
routers. Support for VoHDLC on the Cisco MC3810 multiservice
concentrator was removed.
12.1(2)T Support was added for VoATM on Cisco MC3810 multiservice
concentrators.