Cisco IOS Voice, Video, and Fax Commands: R Through Sh
show sgcp connection
VR-787
Cisco IOS Voice, Video, Fax Command Reference
show sgcp connection
To see all active SGCP connections on this router, use the show sgcp connection command in EXEC
mode.
show sgcp connection [interface number]
Syntax Description
Defaults No default behavior or values.
Command Modes EXEC
Command History
Usage Guidelines If you do not specify an interface, this command shows all the active SGCP connections on this host. If
you specify an interface, this command shows only those active connections on the specified interface.
Examples The following example shows the active connections on this router being displayed:
Router# show sgcp connection
Endpoint Call_ID(C) Conn_ID(I) (P)ort (M)ode (S)tate (E)vent[SIFL] (R)esult[EA]
1. ds1-0/1@r3810-5 C=1,1,2 I=0x1 P=16492,16476 M=3 S=4 E=3,0,0,3 R=0, 0
The following example shows the state of SGCP on the router being displayed:
Router# show sgcp connection
SGCP Admin State DOWN, Oper State DOWN
SGCP call-agent: 209.165.200.225 , SGCP graceful-shutdown enabled? FALSE
SGCP request timeout 40, SGCP request retries 10
Table 55 describes the significant fields shown in the display.
interface (Optional) Specifies a DS1 interface.
number (Optional) Specifies the T1 interface (controller) number. Valid
values on the Cisco MC3810 multiservice concentrator are from
0 to 1.
Release Modification
12.0(5)T This command was introduced in a private release on the
Cisco AS5300 universal access server only and was not generally
available.
12.0(7)XK Support for this command was extended to the Cisco MC3810
multiservice concentrator and the Cisco 3600 series routers
(except for the Cisco 3620) in a private release that was not
generally available.