Filter
Top Products
Cisco IOS Voice, Video, and Fax Commands: R Through Sh
retry-delay
VR-571
Cisco IOS Voice, Video, Fax Command Reference
retry-delay
To set the time between attempts to connect with the settlement provider, use the retry-delay command
in settlement configuration mode. To restore the default value, use the no form of this command.
retry-delay number
no retry-delay
Syntax Description
Defaults The default retry delay is two seconds.
Command Modes Settlement configuration
Command History
Usage Guidelines After exhausting all service points for the provider, the router is delayed for the specified length of time
before resuming connection attempts.
Examples The following example sets a retry value of 15 seconds:
settlement 0
relay-delay 15
Related Commands
number Length of time (in seconds) between attempts to connect with the settlement
provider. The valid range for retry delay is from 1 to 600 seconds.
Release Modification
12.0(4)XH1 This command was introduced on the Cisco 2600 and 3600 series routers and
the Cisco AS5300 universal access server.
12.1(1)T This command was integrated into Cisco IOS Release 12.1(1)T.
Command Description
connection-timeout Configures the time for which a connection is maintained after completion
of a communication exchange.
customer-id Identifies a carrier or ISP with a settlement provider.
device-id Specifies a gateway associated with a settlement provider.
encryption Sets the encryption method to be negotiated with the provider.
max-connection Sets the maximum number of simultaneous connections to be used for
communication with a settlement provider.
response-timeout Configures the maximum time to wait for a response from a server.
retry-limit Sets the maximum number of attempts to connect to the provider.