Cisco Systems VR-561 Doll User Manual


 
Cisco IOS Voice, Video, and Fax Commands: R Through Sh
show dialplan incall number
VR-713
Cisco IOS Voice, Video, Fax Command Reference
Examples The following example shows that an incoming call from interface 1/0/0:D with a calling number of
12345 is matched to POTS dial peer 10:
Router# show dialplan incall 1/0/0:D number 12345
Macro Exp.: 12345
VoiceEncapPeer10
information type = voice,
tag = 10, destination-pattern = `123..',
answer-address = `', preference=0,
numbering Type = `unknown'
group = 10, Admin state is up, Operation state is up,
incoming called-number = `', connections/maximum = 0/unlimited,
DTMF Relay = disabled,
huntstop = disabled,
in bound application associated: DEFAULT
out bound application associated:
permission :both
incoming COR list:maximum capability
outgoing COR list:minimum requirement
type = pots, prefix = `',
forward-digits default
session-target = `', voice-port = `1/0/0:D',
direct-inward-dial = disabled,
digit_strip = enabled,
register E.164 number with GK = TRUE
Connect Time = 0, Charged Units = 0,
register E.164 number with GK = TRUE
Connect Time = 0, Charged Units = 0,
Successful Calls = 0, Failed Calls = 0,
Accepted Calls = 0, Refused Calls = 0,
Last Disconnect Cause is "",
Last Disconnect Text is "",
Last Setup Time = 0.
Matched: 12345 Digits: 3
Target:
The following example shows that if no dial peer has a destination pattern or answer address that matches
the calling number of 888, the incoming call is matched to POTS dial peer 99, because the call comes in
on voice port 1/0/1:D, which is the voice port configured for this dial peer:
Router# show dialplan incall 1/0/1:D number 888
Macro Exp.: 888
VoiceEncapPeer99
information type = voice,
tag = 99, destination-pattern = `99...',
answer-address = `', preference=1,
numbering Type = `national'
group = 99, Admin state is up, Operation state is up,
incoming called-number = `', connections/maximum = 0/unlimited,
DTMF Relay = disabled,
huntstop = disabled,
in bound application associated: DEFAULT
out bound application associated:
permission :both
incoming COR list:maximum capability
outgoing COR list:minimum requirement
type = pots, prefix = `5',