Filter
Top Products
82 TPS-System 1000 Programs-2.3.1en © Leica
IV
EL
AH
OH
BS
SM
AS
FS
Measure Mode
This dialog is similar to the TPS System 1000’s basic
"MEASURE MODE" dialog. Once a measurement is
taken, the program will return to the dialog "DEFINE
POINT" to acquire the next point for measuring.
If the station coordinates can be calculated successfully
from the first few measurements, the ∆ Hz and ∆V
values are displayed for further entered target points.
Motorized theodolites will automatically drive the
telescope to the target point.
Simultaneously measure and record data on the active
recording device. Return to the dialog "TARGET
POINT".
Measure a distance.
Record the measurement on the active recording device.
Return to the dialog "TARGET POINT".
Enter target data. For further information, please refer
to chapter "Measure & Record" described in the
"System" - user manual.
Change the theodolite face.
Call up the CODE function, as described in chapter
"Measure & Record" described in the "System" - user
manual.
Exit the program.
Accept the measurement and return to the dialog
"TARGET POINT".
FREST\MEASURRE MODE (GSI)
14:03
ALL DIST REC TARGT
F1
F2 F3
F4
F5 F6
Point no. : 12
Hz : 286°55'50"
V : 91°16'20"
Refl.Height : 1.500 m
Slope Dist. : 22.039 m
∆Hz : -----
HELP I<>II
MC