Filter
Top Products
© Leica TPS-System 1000 Programs-2.3.1en 47
IV
EL
AH
OH
RE
Dual-face Measurement
In the dual-face mode, the program will prompt for
measurements in both faces. When both measurements
are taken, the program will check the difference
between the two. If the difference in angle is within 27'
(0.5 gon) and the difference of two measured distances
is within 0.5 m (1.64 ft), the observations will be
averaged.
These tolerances are used to avoid errors in target
identification.
If exceeded an error message will be displayed.
Log File
If "Log File" is set to "ON" the measurements and the
results are stored in the ASCII-file specified within the
"Configuration Editor". This file is created in the
directory LOG on the memory card. Subsequently, you
can read the memory card on your PC and obtain a hard
copy of the Log-file.
Data will always be appended to the specified Log-file.
The Log-file contains the following information:
Header The header line will contain the
program used, information about the
instrument, the name of the data file as
well as date and time.
Record For each measurement, a record will
be stored containing :
Station coordinates and orientation
correction, standard deviation for
Easting, Northing, Height of station
and orientation correction.
The residuals for horizontal angles,
heights and measured distances are
also listed.