Filter
Top Products
304 TPS-System 1000 Programs-2.3.1en © Leica
IV
EL
AH
OH
BS
SM
AS
FS
BL
HB
KM
FB
SA
PZ
LB
TB
CO
RP
FE
Editing files
It is possible to insert also a new data set:
• With function "Coordinate", point coordinates,
station coordinates or a code block can be inserted.
• With function "Horizontal Alignment" a tangent, a
circular curve, a Spiral in, a Spiral out, a Curve in or
a Curve out can be inserted.
For the circular curve radius the following sign rule
applies:
With a right-hand curve (centre of circle right of
alignment) the sign is positive.
With a left-hand curve (centre of circle left of
alignment) the sign is negative.
• With function "Vertical Alignment" a tangent, a
circular curve or a parabola can be inserted.
For the circular curve radius and/or the parabola
parameter the following sign rule applies:
If the centre of circle is above the alignment (dip) the
sign is positive.
If the centre of circle is below the alignment (crest)
the sign is negative.
• With function "Template" an offset or a height
difference relative to axis can be inserted.
For the offset and/or the height difference the
following sign rule applies:
If the point is left of alignment the offset is negative.
If the point is right of alignment the offset is positive.
If the point is above the alignment the height
difference is positive.
If the point is below the alignment the height
difference is negative.
• With function "Station Equation" a number for the
station equation, a station ahead or a station back can
be inserted.
• With function "Cross-section Assignment" the name
of the template and the start station for this template
can be inserted.