Filter
Top Products
© Leica TPS-System 1000 Programs-2.3.1en 255
IV
EL
AH
OH
BS
SM
AS
FS
BL
HB
KM
FB
SA
PZ
LB
TB
CO
RP
Crs. Intrpl. : The abbreviation means "Cross
Section Interpolation". When this is
set to ON, cross sections will be
interpolated both along and between
cross sections. The interpolation
between cross sections makes
superelevation and widening possible.
If cross section interpolation is enabled, all cross
sections must have the same number of points.
Use the key to toggle between
OFF and ON.
Crs. Movemnt: This function controls the movement
along the cross section.
Press to display the movement
options. There are three choices:
LEFT to RIGHT, RIGHT to LEFT
and NONE. The direction chosen is
for display purposes only. The
rodperson can go in any direction
desired along the cross section.
Hinge Mode : Normal: The points farest away from
the axis are used for calculation of the
slope piercing point.
Not from End Pts: The points farest
away from the axis are not used for
calculation of the slope piercing point,
i.e. the slope piercing point is already
available in the cross section
definition (catch point between digital
ground pattern and cross section).