Filter
Top Products
202 TPS-System 1000 Programs-2.3.1en © Leica
IV
EL
AH
OH
BS
SM
AS
FS
BL
HB
KM
FB
SA
PZ
RO
The Header
41....+00Job-ID 42....+TEMPLATE
WI 41 Job-ID: Job identification consists of 8
alphanumeric characters.
WI 42 Fixed name of the template file. May not be
changed.
The data block
11....+TMPLNAME 35..10+DISTANCE 36..10+000HDIFF
WI 11 TMPLNAME: Name/number of the cross
section, consisting of 8 alphanumeric
characters. The following designations are
reserved and may not be used: 00000NON
and LASTTMPL.
WI 35 DISTANCE: Centre-line offset of a
transverse-profile point. 8-digit number.
WI 36 HDIFF: Height difference of a transverse-
profile point. 8-digit number
Also:
• The header must always be at the start of a data file.
• The file must contain at least one cross section.
• Profile points belonging to the same cross section
must always be together in a single data set. The
points need not be sorted within the data set.
• The individual transverse-profile data sets need not
be sorted within the template file.
• For a cross section file there is a limitation of 200
data blocks. The maximum number of points in a
cross section is 48.