Filter
Top Products
224 TPS-System 1000 Programs-2.3.1en © Leica
IV
EL
AH
OH
BS
SM
AS
FS
BL
HB
KM
FB
SA
PZ
LB
TB
CO
If "Bearing" is selected in the configuration during
"Direc. Type:", then the following dialog box appears:
COGO\ BEARING #1
14:03
F1
F2 F3
F4
F5 F6
HELP MODIF
MC
Direction from first point
Quadrant : 1
NorthEast : 0°00'00"
Offset : 0.000 m
INV RCALL EDIT
Quadrant : Enter quadrant (First or second
straight lines)
1 = Northeast
2 = Southeast
3 = Southwest
4 = Northwest
NorthEast : Enter magnetic bearing (First or
second straight lines)
If "Azimuth" is selected in the
configuration during "Direc.Type:",
then the azimuth of the first straight
line (or the second straight line) can
be entered.
Offset : Entering parallel displacement.
Only active if "YES" is entered in the
configuration during "Offset:"
Left = negative parallel offset
Right = positive parallel offset
Determining the direction by means of the function
"Polar calculation" (refer to chapter "Inverse").