Filter
Top Products
216 TPS-System 1000 Programs-2.3.1en © Leica
IV
EL
AH
OH
BS
SM
AS
FS
BL
HB
KM
FB
SA
PZ
LB
TB
CO
Defining direction by
Azimuth
If "Azimuth" is selected in the configuration during
"Direc. Type:", then the following dialog box appears:
COGO\ TRAVERSE
14:03
F1
F2 F3
F4
F5 F6
HELP MODIF
MC
Direction to Traverse
Azimuth : 0°00'00"
Offset : 0.000 m
INV RCALL EDIT
Determining the direction by means of the function
"Polar calculation" (refer to chapter "Inverse").
INPUT Entering Azimuth
RCALL Call up of a direction which has been
previously stored using the function
"Polar calculation".
Accept displayed values and proceed with dialogue
"TRAVERSE" (page 218).
Changing the direction (refer to dialogue "MODIFY
AZIMUTH ", page 217)
Exit the program.
Azimuth : Entering Azimuth
Offset : Entering parallel displacement.
Only active if "YES" is entered in the
configuration during "Offset:"
Left = negative parallel offset
Right = positive parallel offset