Filter
Top Products
130 TPS-System 1000 Programs-2.3.1en © Leica
IV
EL
AH
OH
BS
SM
AS
FS
BL
HB
KM
FB
SA
Sets Menu
Sets menu - view
The point numbers and sequence of the targets are
stored in the program during the observation of the first
half set in face I. This is designated as the "Learning
Phase". The observer is thereafter guided throughout
the observation sequence, i.e. the targets are proposed
as per "learned" sequence using the selected
observation method. To locate the targets easily, the
horizontal and vertical differences in direction are
displayed. Turning these differences to "zero", the
relevant target is visible. Motorized theodolites will
automatically drive the telescope to the specified target
point, if the first half set was measured successfully.
Complete directions must be observed for all targets
within the first set. A complete direction is defined as a
direction observed in both faces.
During observation the program tests, if the correct face
is used. As soon as the last "learned" target has been
observed, the program changes automatically to face II.
F1
F2 F3
F4
F5 F6
HELP CONF
SETS\ SETS MENU
14:03
MC
Start the "CONFIGURATION".
Measure First Set 0
Measure Further Set 1
Calculate Horizontal Sets 2
Calculate Vertical Sets 3
End Program 4