Filter
Top Products
218 TPS-System 1000 Programs-2.3.1en © Leica
IV
EL
AH
OH
BS
SM
AS
FS
BL
HB
KM
FB
SA
PZ
LB
TB
CO
Defining horizontal
distance
COGO\ TRAVERSE
14:03
F1
F2 F3
F4
F5 F6
HELP MODIF
MC
Distance to Traverse
Horiz.Dist. : 0.000 m
Offset : 0.000 m
INV RCALL EDIT
Horiz Dist : Entering horizontal distance
Offset : Entering parallel displacement.
Only active if "YES" is entered in the
configuration during "Offset:"
Left = negative parallel offset
Right = positive parallel offset
Determining the distance by means of the function
"Polar calculation" (refer to chapter "Inverse").
INPUT Entering horizontal distance
RCALL Call up of a distance which has been
previously stored using the function
"Polar calculation".
Accept displayed values and proceed to dialogue
"TRAVERSE RESULTS" (page 220).
Changing the distance (refer to dialogue "MODIFY
DISTANCE", page 219).
Exit the program.