Filter
Top Products
© Leica TPS-System 1000 Programs-2.3.1en 179
IV
EL
AH
OH
BS
SM
AS
FS
BL
HB
KM
FB
SA
PZ
RO
Element : The element type on which the
chainage displayed is located.
The elements are output in full. Both
adjacent elements are displayed in the
main points.
Offset : Horizontal displacement (offset) of
the point to be set out in relation to the
centre line.
HghtOffset : Height displacement of the point to be
set out in relation to the centre line.
(The amount of the vertical
displacement is also taken into
account.)
Hght. Shift : All heights in the alignment are
changed by this amount. The value
can only be changed in the dialog
"CONFIGURATION".
ChaingeIncr : The chainage difference when setting
out. The chainage is automatically
incremented by this amount.
Calls the function "X-SECTION CHECK".
Displays the next chainage up which is divisible by
ChaingeIncr. If the end of the alignment is overshot, a
warning is given once. After the end of the alignment,
the calculation is based on the tangent of the last
element.
Displays the next chainage down which is divisible by
ChaingeIncr. If there is a shortfall at the beginning of
the alignment, a warning is given once. Before the
beginning of the alignment, the calculation is based on
the tangent of the first element.
Calls the dialog "CROSS SECTIONS".
Calls the dialog "POINT COORDINATES" in order to
display the coordinates of the point to be set out. From
there, calls the program "STAKEOUT".