Filter
Top Products
© Leica TPS-System 1000 Programs-2.3.1en 193
IV
EL
AH
OH
BS
SM
AS
FS
BL
HB
KM
FB
SA
PZ
RO
The header
41....+00Job-ID 42....+HZALIGNM 43....+STACOORD
WI 41 Job-ID: Job identification consists of 8
alphanumeric characters.
WI 42 Fixed name of the Hz-alignment file. May
not be changed.
WI 43 Fixed name of the main-point method. May
not be changed.
Element Defined by: Declaration
Straight Starting point [E, N] STRAIGHT
Arc Start of curve [E, N],
radius R.
000CURVE
Spiral into curve
starting with
R= *)
Start of curve [E, N],
A-parameter
00SPIRIN
Spiral out of curve
ending at R= *)
Start of curve [E, N],
A-parameter
0SPIROUT
End of project End point [E, N] 00000EOP
∞
∞
*) The spiral must begin or end with R = ∞ .
The Hz-alignment file is structured as follows:
1. Header
2. Data block: Definition 1st geometrical element
3. Data block: Definition 2nd geometrical element
4. Data block: Definition 3rd geometrical element
.....
n. Data block: Definition of end of project