Filter
Top Products
114 TPS-System 1000 Programs-2.3.1en © Leica
IV
EL
AH
OH
BS
SM
AS
FS
BL
HB
HP
Measure Rod
The program will display the TPS 1000 "Measure &
Record"dialog or the dialog shown below.
If the difference of the given and measured spacing
between the reflectors exceeds the "Meas. Tol. limit" a
message is displayed.
You may accept the measurement or re-measure the
reflector.
HDNPT\ MEASURE PRISM 1
14:03
MC
Point no. : Station12
Hz : 16°55'50"
V : 91°16'20"
Slope Dist. : ----- m
Height diff : ----- m
ALL DIST REC TARGT
F1
F2 F3
F4
F5 F6
HELP CONF I<>II
Simultaneously measure and record in the active file.
Proceed with the same dialog for the next reflector. If
the last point has already been measured, the program
will proceed to the "RESULT" dialog.
Measure a distance. Record the measurement in the
active file and proceed with the same dialog for the next
reflector. If the last point has already been measured,
the program will proceed to the "RESULT" dialog.
Measure the distance. Accept the measurement without
recording. Proceed with the same dialog for the next
reflector. If the last point has already been measured,
the program will proceed to the "RESULT" dialog.
The prism constant used in the program is shown in the
distance measurement display during the distance
measurement. The prism name also shown in this
display has nothing to do with the prism constant and
can be ignored.