Leica 1000Z01 Model Vehicle User Manual


 
© Leica TPS-System 1000 Programs-2.3.1en 129
IV
EL
AH
OH
BS
SM
AS
FS
BL
HB
KM
FB
SA
Sets of Angles
Introduction
This manual describes the "Sets of Angles" program of
the TPS SYSTEM 1000 theodolite series.
PROG_Z16
E
The program permits direction measurements to targets
of which coordinates are not necessarily known. The
average direction of all sets, the standard deviation for
one observed direction and the standard deviation for
the average of all directions is computed for each target.
To calculate a result, a minimum of two full sets must
be observed. Measurements in two faces must exist for
each target .
Once the program has "learned" the targets and their
respective sequence during the first set in face I, the
observer is guided throughout the following measuring
sequence.
A maximum of 250 measurements per instrument
station (in 2 faces) can be handled in one calculation.
Pt3
Pt2
Pt1
H
N
Set2 (0°00'00")
Set1(0°00'00")