Filter
Top Products
254 TPS-System 1000 Programs-2.3.1en © Leica
IV
EL
AH
OH
BS
SM
AS
FS
BL
HB
KM
FB
SA
PZ
LB
TB
CO
RP
Configuration
Start the "Configuration-Editor" from the "SELECT
ALN FILES" dialog.
ROAD+\ CONFIGURATION
14:03
MC
INFO DFLT EDIT
3D Stake : ON
Crs.Intrpl. : OFF
Crs.Movemnt : Left > Right
Hinge mode : normal
Log File : ON
Log FlName : ROAD.LOG
Base Chainge : Enter the beginning chainage for the
project
End Chainge : Enter the ending chainage for the
project
Chainge Incr : Enter the chainage interval to be used
Hght. Shift : Enter a vertical shift value if needed.
The value entered will be applied to
the whole alignment.
Deflct. Tol. : Enter an angle tolerance for deflection
angles. Make this a small value but
not 0.
Chainge Tol. : Enter a value for chainage tolerance.
This value will determine how close
the point will be to a 0 location.
3D Stake : Use the key to toggle between
OFF or ON. For cut/fill capability this
should be set to ON.
Base Chainge: 0.000
End Chainge : 89.270
Chainge Incr: 10.000 m
Hght. Shift : 0.000 m
Deflct. Tol.: 0°00'16"
Chainge Tol.: 0.010 m
F1
F2 F3
F4
F5 F6
HELP