Filter
Top Products
© Leica TPS-System 1000 Programs-2.3.1en 147
IV
EL
AH
OH
BS
SM
AS
FS
BL
HB
KM
FB
SA
TR
Traverse
Introduction
This manual describes the "Traverse" program of the
TPS-System 1000 instruments.
PROG_Z17
E
H
N
Pt500
SP1
Hz2 Hz3
Hz1
Pt1
Pt2
Pt3
Pt501
Using data about direction and distance, the program
continuously computes the coordinates of the station (in
the example shown above, the instrument "moves" from
one station to the next, previously measured point) and
aligns the horizontal circle.
For a point the coordinates of which are known, the
deviation from the coordinates determined by
measurement can be computed and displayed.
There is no adjustment of these differences in
coordinates and direction. Subsequently, however, the
measurements stored on the PCMCIA can be processed
with the assistance of an appropriate software program.
Individual stations can be calculated as "sideshots"
(SP). The coordinates and directions of these points are
also determined in the course of this program.
If the program is terminated (e.g. to record a detail
point), the values remain stored. The measurement
procedure can be resumed after calling up the program
again.