Filter
Top Products
296 TPS-System 1000 Programs-2.3.1en © Leica
IV
EL
AH
OH
BS
SM
AS
FS
BL
HB
KM
FB
SA
PZ
LB
TB
CO
RP
Cross Sections
Geometric elements supported:
Header of the cross section file:
41....+00JOB_ID 42....+TEMPLATE
WI41 Job identification. Max. 8 ASCII characters,
user definable.
WI42 Template file identification. May not be
changed by user.
A data block for a cross section is structured as
follows:
11....+ PROF_NR 35....+DISTANCE 36....+000HDIFF
WI 11 The cross section number.
WI 35 Horizontal distance from the centerline.
WI 36 Height difference from the centerline.
WI 71 Cross section type.
WI 72 Slope ratio.
Element Definition
Height differences Height difference to the centerline
Distance Distance from the centerline
Cross section type Differentiate between CUT and
FILL cross sections
Slope slope ratio
Comments:
• The header consists of a single block at the start of a
data file.
• All data blocks having the same cross section
number (WI11) belong together.
• All data blocks belonging to a cross section must be
consecutive in the file to minimize file access.
• The data blocks for a cross section must be sorted by
ascending distance from the centerline.