Filter
Top Products
174 TPS-System 1000 Programs-2.3.1en © Leica
IV
EL
AH
OH
BS
SM
AS
FS
BL
HB
KM
FB
SA
PZ
RO
Program concept
The "ALIGNMENT CALCULATION" program only
permits measurements in one face.
Before the program is started, the following procedures
are carried out:
1. Setting user profile and name of the data file.
2. Determining the instrument station and the
orientation
"ROAD STAKEOUT" requires the following input:
1. Chainage for the point to be set out
2. Offset and height displacement of the point to be set
out, or zero point of cross section relative to axis
(optional)
3. Selection of a point on the cross section (optional)
On the basis of this input, the coordinates of the point to
be set out are determined and are transferred to the
program "SETTING OUT" for post-processing.
The "X-SECTION CHECK" requires the following
input:
1. Measurement to ground point
The parameters calculated and displayed are
respectively the chainage, the offset, and the height
difference of the point measured with respect to the
centre-line.