Filter
Top Products
252 TPS-System 1000 Programs-2.3.1en © Leica
IV
EL
AH
OH
BS
SM
AS
FS
BL
HB
KM
FB
SA
PZ
LB
TB
CO
RP
Creating Data Files
There are two methods that can be used to create the
necessary data files. If the program called "FILE
EDITOR" is loaded into the theodolite, all necessary
data for a given component can be entered through the
keyboard. To enter data on the computer a DOS pro-
gram called "ROADDATA.EXE" can be used. If you
create the files using the "ROADDATA.EXE" program,
the files must be copied to the PCMCIA card in a
directory called GSI.
The following table shows an overview of the max. file
sizes:
Type of file Limitations
Horizontal
alignment
No limitation for "RoadPlus";
max. 200 blocks for "File Editor"
Vertical
alignment
No limitation for "RoadPlus";
max. 200 blocks for "File Editor"
Cross section 200 data blocks
(number of points in a cross section
max. 48)
Cross section
assignment
100 data blocks
Station equation 100 data blocks
Program Overview
"ROADPLUS" allows measurements in one telescope
position only. A typical "ROADPLUS" session includes
the following steps:
1. Enter setup information for the instrument and orient.
2. Start the ROADPLUS program and configure.
3. Select the alignment files
4. Select a station
5. Pick a point on the cross-section to stakeout, enter an
offset, choose method.