2-3
Automated Verification
Step 1. Initialization
How to select the system verification procedure
Check to see how the verification kit floppy disk is labeled:
• If the disk is labeled
Verification Data Disk
, proceed with the Agilent 8702D Auto-
mated Mode System Verification in this chapter.
• If the disk is labeled
Verification Data Disc
, proceed with the Agilent 8702D Manual
Mode System Verification procedure, located in Chapter 3, “Manual Verifica-
tion”.
Step 1. Initialization
1
Connect the equipment as shown in Figure 2-1. Let the Agilent 8702D warm up
for one hour.
Figure 2-1. System Verification Test Setup
2
While the equipment is warming up, review the connector care information in
the
Agilent 8702D User’s Guide
.
NOTE
If your verification disk is older than your Agilent 8702D, you may send your
Agilent 85029B Option 001 7 mm verification kit to the nearest service center for recerti-
fication, which includes a data disk that you can use with the Agilent 8702D.