Agilent Technologies 87020 Stroller User Manual


 
1-14
Installing the Agilent 8702D
Step 10. If You Connect a Plotter
Step 10. If You Connect a Plotter
1
Press
LOCAL
,
SET
ADDRESSES
,
PLOTTER PORT
.
2
Press the key that corresponds to the plotter interface:
HPIB
,
PARALLEL
(parallel
port), or
SERIAL
(serial port).
3
If you selected
HPIB
, the GPIB address is active so you can then set the address
of your plotter. The default GPIB plotter address is 5.
4
If you select
SERIAL
, adjust the Agilent 8702Ds baud rate and handshaking
protocol:
a
Press
PLOTTER BAUD RATE
, and use the up and down arrow front-panel keys to
select the baud rate.
b
Set the transmission control,
XMIT CNTRL
(handshaking protocol) to either
XON/XOFF
or
DTR/DSR
(equal to the transmission control set on the peripher-
al).
XON/XOFF
selects software handshaking.
DTR/DSR
selects hardware
handshaking. Consult the printers manual for the proper settings.
5
Press
PLTR
TYPE
until the correct plotter selection appears:
Choose
PLTR TYPE [PLOTTER]
if you will be using a plotter to make your hard-
copy.
Choose
PLTR TYPE [HPGL PRT]
if you will be using an HPGL compatible printer
to make your hardcopy.