1-13
Installing the Agilent 8702D
Step 9. If You Connect a Printer
Step 9. If You Connect a Printer
1
Press
LOCAL
,
SET
ADDRESSES
,
PRINTER
PORT
.
2
Press the key that corresponds to the printer interface:
HPIB
,
PARALLEL
(parallel
port), or
SERIAL
(serial port).
3
If you selected
HPIB
, the GPIB address is active so you can then set the address
of your printer. The default GPIB printer address is 1.
4
If you select
SERIAL
, adjust the Agilent 8702D’s baud rate and handshaking
protocol:
a
Press
PRINTER BAUD RATE
, and use the up and down arrow front-panel keys to
select the baud rate.
b
Set the transmission control,
XMIT CNTRL
(handshaking protocol) to either
XON/XOFF
or
DTR/DSR
(equal to the transmission control set on the peripher-
al).
XON/XOFF
selects software handshaking.
DTR/DSR
selects hardware
handshaking. Consult the printer’s manual for the proper settings.
5
Press
PRNTR
TYPE
until the correct printer choice appears:
•
ThinkJet
(QuietJet)
•
DeskJet
(except for HP
1
DeskJet 540)
• LaserJet
• PaintJet
•
Epson-P2
(printers that conform to the ESC.P2 printer control language)
•
DJ540
(converts 100 dpi raster information to 300 dpi raster format)
1. HP is a registered trademark of Hewlett-Packard Company.